3.
4.
5.
6.
7.
8.
The unit will now have the correct DATA for the new MEMORY IC.
NOTE FOR THE REPLACING OF MEMORY IC
If a service repair is undertaken where it has been required to change the MEMORY IC, the following steps should be taken to
ensure correct data settings while making reference to TABLE 1.
NOTE: Initial Data setting will not be possible if clock has been set. To reset clock, either unplug AC cord and allow
at least 5 seconds before Power On.
Table 1
1.
2.
Fig. 1
ADDRESS is now selected and should "blink". Using the SET + or - keys on the remote, step through the ADDRESS until
required ADDRESS to be changed is reached.
Press ENTER to select DATA. When DATA is selected, it will "blink".
Again, step through the DATA using SET + or - until required DATA value has been selected.
Pressing ENTER will take you back to ADDRESS for further selection if necessary.
Repeat steps 3 to 6 until all data has been checked.
When satisfied correct DATA has been entered, turn POWER off (return to STANDBY MODE) to finish DATA input.
Enter DATA SET mode by setting VOLUME to minimum.
While holding down VOLUME button on front cabinet, press key 6 on remote control simultaneously.
ADDRESS and DATA should appear as FIG 1.
INIT 00 83
0010
0003
POWER ON
PLAY/REC
ADDRESS
DATA
ADDRESS
DATA
00
88
01
1B
02
C0
03
63
04
43
05
23
06
34
07
29
08
51
09
30
ADDRESS
DATA
0A
18
0B
90
0C
99
0D
0C
0E
1A
0F
0A
10
8C
11
68
12
5C
13
53
ADDRESS
DATA
14
00
15
00
16
30
17
05
18
05
19
00
1A
A9
1B
32
1C
05
1D
39
ADDRESS
DATA
1E
0A
1F
00
20
00
21
00
22
00
23
00
24
00
25
00
26
00
27
00
ADDRESS
DATA
00
28
01
29
