P9 ASD Quick Start Guide
25
place. This ensures the proper alignment and electrical connection of the CNX connector of the LED/LCD
display unit PCB. Gently hold the display in place while securing the Phillips mounting screw.
If improperly seated, the periphery of the LED/LCD display unit will not be flush with the EOI surface
and the unit will not function properly.
Real-Time Clock Setting
The Real-Time Clock of the P9 ASD provides a time stamp of the trip history, Time-Based Alternation
control timing, and other real-time event control functions.
The Real-Time Clock must be set in order to use the real-time monitoring and control functions of the
ASD (trip history dates, Time-Based Alternation, etc.).
Set the Real-Time Clock from Program\Utilities\
Real-Time Clock Setup
. Scroll to select the field to be
changed. Press
Enter
to enter the
Edit
mode. Turn the rotary encoder to change the value. Once set, press
Escape
to exit without accepting the change, or press
Enter
to accept the change.
Continue to subsequent fields of the
Real-Time Clock Setup
screen
and repeat the procedure until done.
EOI Remote Mounting
The EOI may be mounted remotely using the optional
ASD-MTG-KIT-P9
. The kit contains all of the
hardware required to mount the EOI of the 9-Series ASD remotely.
System operation and EOI operation while using the remotely-mounted EOI are the same as with the
ASD-mounted configuration.
See the
P9 ASD Installation and Operation Manual
for more information on mounting the EOI remotely.
eal-Time
ock Setup
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www .ctiautomation.net - Email: info@ctiautomation.net
