8
BOILING/POURING
BOILING
Put the water in the pot and close the lid.
Connect the plug. Then press the
TEMP.
CLEAN
button to select the
temperature.
:
The BOIL indicator will light
up. And after the selected
TEMP indicator (
)
flashes about 2 seconds,
the display will light up
instead.
[
The display will show the
raising water temperature
by 5°C at a time. If the temperature is lower than
15°C, Lo will appear.
The displayed temperature is as a measure. It may
change depending on the amount of water or the
room temperature.
L
When selecting the temperature of “98”
:
When the water boils, the
BOIL indicator will light off
and the WARM indicator will
light up noticeably.
L
When selecting the temperature of “85”
and “60”
:
When the water boils, the
BOIL indicator will light off and
the selected WARM indicator
will flash
:
When reaching the selected
temperature, the WARM
indicator will light up
noticeably.
Indication
For
[
The time range of water boiling
[
2.5L: About 20 minutes
(Approx. water level: Maximum water/the
room and water temperature 20°C)
[
The range of time after boiling
to the temperature of “85”
[
2.5L: About 50 minutes
[
The range of time after boiling
to the temperature of “60”
[
2.5L: About 3 hours and 10 minutes
(The amount of any hot water: maximum
water/the room temperature: 20°C)
NOTE
[
Do not fill the water while the water tempera
ture is decreasing. The water may not boil
when reaching the selected warm temperature.
At the temperature of “98”
Coffee, Chinese tea, instant
cup noodle, etc.
At the temperature of “85”
Japanese tea, etc.
At the temperature of “60”
Mixing milk, etc. (After
melting the milk powder, let
it cool down to the proper
temperature.)
(Cleaning)
Refer to page 13.
NOTICE
[
Although the power cord is unplugged, the
previous set temperature will not change until the
temperature is adjusted next time.
[
The boiling point will change upon the land level
and the pressure. Then the selected warm
temperature will also change. (In case the
selected temperature is “98”.)
[
If the room temperature is higher after the water
boils, it will take more time to reach the selected
temperature.
[
The warming temperature can be altered although
the water is being warmed. The boiling point will
depend on the water temperature at that time.
[
In case of using the ionized alkaline liquid, the
resin will return yellow.
EMPTY
TIMER
REDUCE
CHLORINE
CLEAN
WARM
BOIL
EMPTY
TIMER
REDUCE
CHLORINE
CLEAN
WARM
BOIL
EMPTY
TIMER
REDUCE
CHLORINE
CLEAN
WARM
BOIL
EMPTY
TIMER
REDUCE
CHLORINE
CLEAN
WARM
BOIL
EMPTY
TIMER
REDUCE
CHLORINE
CLEAN
WARM
BOIL
CLEAN
CLEAN
CLEAN
CLEAN
NENL13710000000 (02-10)
24/3/08, 13:50
8
