9
PUMP
When there is very little water
Fill the water before the water
reaches the water level gauge
When not in use
Unplug the power cord and detach
the lid. After that, pour out all the
water.
L
Regarding the prevention to warm
the empty pot
To prevent the accident from overheating, if it is
found that the empty pot is warmed (for example,
there is the distribution of power supply when the
pot is empty.), the electric current distributed to the
heater will be cut off and it is noticeable from the
indicator flashing.
;
Please fill the water and press the
REBOIL
TIMER
button.
[
If the empty pot is warmed many times, the
coated fluorocarbon-resin may discolor or peel
away.
POURING
WARNING
Do not turn over or tilt the pot.
Do not terribly shake (especially shake
up and down) or strike the pot.
Do not hold the lid while moving the
pot.
The water will flow out from the water
dispenser or the steam vent. Then the
pot may slip and fall down, and cause
some burns and injury.
1
Press the UNLOCK button, then
the button will be unlocked.
:
The UNLOCK indicator will light up.
[
About 2 seconds after the pot is unlocked,
the water can be poured out. And 2 minutes
later, the pot will be automatically locked.
2
Place the cup under the water
dispenser and press the PUMP button.
Then, the water will pour out.
[
The UNLOCK indicator will light up.
When wanting to lock right after pouring water
Press the UNLOCK button and the UNLOCK
indicator will light off
PROHIBITED
UNLOCK
PUMP
UNLOCK
EMPTY
TIMER
CHLORINE
CLEAN
WARM
BOIL
REDUCE
Flashing
Flashing
alternately
NENL13710000000 (02-10)
25/3/08, 13:08
9
