User’s Manual
7-3
HW Setup and Passwords
3. Click the
OK
button. If the character string you enter matches the
registered password, the password option is reset and the display
changes to:
S
The password was deleted
If they do not match, the following message appears. You must repeat step 1.
S
Incorrect Password
4. Follow the same procedures described in the earlier section, How to set
the password, to set a new user password.
Refer to the
Supervisor password
section later in this chapter for details on
setting the supervisor password.
Display
This tab lets you customize your computer’s display settings for either the
internal LCD screen or for an external monitor.
Power On Display
Lets you use the display to be used when the computer is booted.
If you click the
OK
button before entering the password,
Registered
will
appear on the display.
If you enter the password incorrectly three times, the LCD screen will
display:
Sorry, access denied!!! Powering off your machine then
powering it back on again are required to regain
access.
You will not be able to access the password option in the HW Setup. In this
case you must turn the power off and back on to retry the procedure.
Auto-Selected
Selects an external monitor if one is connected.
Otherwise, it selects the internal LCD (Default).
LCD + Analog RGB
Selects both the internal LCD and external
monitor for simultaneous display.
If the connected external monitor does not support the SVGA mode,
selecting the LCD + Analog RGB mode will not display the screen on that
monitor.
At Windows start-up, the screen is displayed on the external monitor if it
was connected at the time of the previous power-off, and is found at the
start-up. Otherwise, the screen is displayed on the internal LCD.