User’s Manual
7-6
HW Setup and Passwords
HDD Priority Options
If more than one HDD is installed in the computer, this option lets you set
the priority for HDD detection. If the first detected HDD has a boot
command, the system will boot from the HDD.
Network Boot Protocol
This feature sets the protocol to remotely boot from the network.
[PXE]
Sets PXE as the protocol (Default).
[RPL]
Sets RPL as the protocol.
Keyboard
Wake-up on Keyboard
When this feature is enabled and the computer is in Standby mode, you
can turn on the computer by pressing any key. It is effective only for the
internal keyboard and only when the computer is in standby mode.
Built-in HDD
−>
PC
Card (Default)
HDDs are searched for a boot command in the
following order: the built-in HDD, and the PC card
(Default).
PC Card
−>
Built-
in HDD
HDDs are searched for a boot command in the
following order: the built-in HDD and the PC card.
If a boot command is not found on the first detected HDD, the system will
not boot from the other HDD. It will search the next device in the boot
priority for a boot command.
Enabled
Enables the Wake-up on Keyboard.
Disabled
Disables the Wake-up on Keyboard (Default).