User’s Manual
8-15
Optional Devices
Connecting
1. Make sure the connectors are properly aligned and plug the i.LINK
(IEEE1394) cable into the i.Link port of your computer.
Connecting the i.LINK cable
2. Plug the other end of the cable into the device.
Note the following when you use i.LINK:
Q
You may need to install drivers for your i.LINK devices.
Q
Not all i.LINK devices have been tested. Therefore, compatibility with all
i.LINK devices cannot be guaranteed.
Q
Use S100, S200 or S400 cables no longer than three meters.
Q
Some devices might not support standby or automatic off functions.
Q
Do not connect or disconnect an i.LINK device while it is using an
application or when the computer is automatically shutting it down to
save power. Data might be destroyed.
Disconnecting
1. Open the
Safety Remove Hardware
icon on the Task Bar.
2. Point to
i.LINK (IEEE1394) device
and click.
3. Disconnect the cable from the computer then from the i.LINK device.
i.Link port
Refer also to the documentation that came with your i.LINK device.