User’s Manual
6-13
Power
Starting the computer by password
To start up the computer with the user password, follow these steps:
1. Turn on the power as described in Chapter 3,
Getting Started
. The
following message appears:
S
Password
=
2. Enter the password.
3. Press
Enter
.
Power-up modes
The computer has the following power-up modes:
Q
Boot: Computer shuts down without saving data. Always save your
work before you turn the computer off in boot mode.
Q
Hibernation: Data in memory is saved to the hard disk.
Q
Standby: Data is maintained in the computer’s memory.
Windows utilities
You can specify the setting in TOSHIBA Power Saver.
Hot keys
You can use hot keys
Fn
+
F3
to enter Standby mode and
Fn
+
F4
to enter
Hibernation. Refer to Chapter 5,
The Keyboard
for details.
At this point, the hotkeys
Fn
+
F1
to
F9
do not work. They will function after
you enter the password.
If you enter the password incorrectly three times in a row, the computer
shuts off. In this case, you must turn the computer back on to retry
password entry.
Refer also to the sections
Turning on the power
and
Turning off the power
in Chapter 3, Getting Started.