User’s Manual
4-14
Operating Basics
DLA for TOSHIBA
Note the following limitations when you use DLA:
■
This software supports only rewritable discs (DVD+RW, DVD-RW, and
CD-RW). It does not support DVD+R, DVD-R, and CD-R discs that are
not rewritable.
■
DLA does not support formatting a DVD-RAM disc and writing to it.
They are performed by DVD-RAM Driver Software. If DLA Format menu
may appear when inserting a DVD-RAM disc into the drive and right-
clicking the drive icon in Windows Explorer, please use "DVDForm" to
format this disc. You can run "DVDForm" by clicking the Start button on
the taskbar to display the Start menu and then selecting "All Programs",
"DVD-RAM", "DVD-RAM Driver" and "DVDForm" sequentially.
■
Do not use any discs that have been formatted with packet writing
software other than DLA. Similarly, do not use any discs that have been
formatted with DLA with any packet writing software other than DLA.
When using a disc you are not familiar with, format it by selecting “Full
Format” before using it.
■
Do not use the Cut & Paste function for files and folders. A file or folder
that has been cut may be lost if writing fails due to an error on the disc.
■
When writing the Setup files for the program to a disc formatted by DLA
and starting Setup from this disc, an error may occur. In this case,
please copy them to your hard disk and then run Setup.
Video
As for InterVideo WinDVD Creator Platinum. Only the model that can be
written in to DVD is attached.
When WinDVD Creator Platinum is used:
You can record video back to your digital camcorder via i.LINK (IEEE1394)
using WinDVD Creator Platinum. However, there is a case where its
playback sound is choppy.
1. Click
Start
and select the
Control Panel
.
2. Click the
Performance and Maintenance
icon in the Control Panel.
3. Click the
System
icon in the Performance and Maintenance window.
4. Click the
Advanced
tab in the System Properties window.
5. Click the
Settings
icon in the "Performance" section.
6. Click the
Advanced
tab in the Performance Options window.
7. Click the
Change
icon in the "virtual memory" section.
8. Select the
Custom size
button in the Virtual Memory window.
9. Specify much higher values for "Initial size" and "Maximum size."
10. Click the
Set
button in the Virtual Memory window.
11. Click the
OK
button in the Virtual Memory window.
