E6581680
6.7. Parameter settings: Diagnostics
The diagram below shows the
"Parameters / Diagnostic"
menu accessible from
"Main menu / Parameters"
.
"Diagnostic / Fault History"
: This menu accesses the detected fault history.
"Diagnostic / Clear Faults"
: This menu is used to clear the detected fault history
Parameters
Diagnostic
Diagnostic
Fault History
Diagnostic
Clear faults
Diagnostic
fault1
Diagnostic
fault2
Diagnostic
fault3
Are you sure to
clear faults?
Clear faults
History done
List of cleared
faults codes
ENT
ESC
ENT
ESC
ENT
ESC
ENT
ENT
ESC
ESC
ESC
See the table of
faults codes
below
Parameter writer display
Probable cause
Remedy
Warning:
Low Battery Level
The battery charge is low. The appearance
of this message depends on the charge
level defined by the user. (See setting
the detection section 6.6)
- Make sure you have a set of replacement
batteries to hand, as the current set have little
life left.
Switch off Low battery
The battery charge is too low.
The Parameter writer will turn off.
- Replace the batteries immediately. No more
transfers can be made.
Store config fault
Incomplete or incorrect transfer to the
inverter.
The inverter is in parameter change
prohibition state.
Load config fault
Incomplete or incorrect transfer from
the Parameter writer to the inverter
The inverter is in parameter read
prohibition state.
- Check the RJ45 cable and both of its
connectors. Make sure the connection is
secure for the duration of the transfer. Restart
the transfer operation.
- Confirm the inverter parameter setting.
Wrong reference Fault
Bad transfer to the inverter; the
configuration
file selected is not compatible with the
destination inverter.
- Check that the configuration file is compatible
with the inverter to be configured.
No device connected
The inverter is not connected or is
incorrectly connected.
- Check the RJ45 cable and both of its
connectors. Make sure the connection is
secure for the duration of the transfer.
Connect the RJ45 cable.
No file selected
No configuration file is selected. There is
no file present on the SD card.
- Select a file to transfer. - Follow the
procedure for loading configuration files
described on section 5.1.
SD card fault
The card is not recognized.
- Check that the SD card is inserted correctly.
- Check that the SD card is formatted correctly.
SD card
Write protected
The SD card is locked.
- Check if the SD card is locked.
Flash FW Fault
For factory use only
-
22
