User Manual
Page 15
Type 1: Hung window installation
1. Cut the adhesive foam seal A and B strips to the proper lengths,
and attach them to the window sash and frame as shown.
2. Insert the window slider assembly into the window track. If the
hose opening is covered by the lip of the window frame, rotate
the panel so the thicker side faces the window frame. Attach the
Window Kit Brace to the back of the hose panel to brace against
the window so the window slider panels do not lean inward.
Foam seal B
(Adhesive type-shorter)
Foam
seal A
(Adhesive
type)
Window
slider A
Window
slider B
(if required)
Installa
tion
Instruc
tions
Window
Kit Brace
Foam seal C
(Non-adhesive type)
Security Bracket
2 Screws
3. Cut the non-adhesive foam seal C strip to match the width of
the window. Insert the seal between the glass and the window
frame to prevent air and insects from getting into the room.
4. If desired, install the security bracket with 2 screws as shown.
5. Attach the hose to the window slider panel by inserting the end
of the hose into the opening on the slider.
