User Manual
Page 41
Oper
ating
Instruc
tions
(W
ith Remot
e)
Energy saver operation
In this mode, the fan will continue to run for 3 minutes after the
compressor shuts off. The fan then cycles on for 2 minutes at 10
minute intervals until the room temperature is above the set
temperature, at which time the compressor turns back on and
cooling stars.
1
NOTE
• Buttons design is based on typical model and might be slightly diff erent from the actual one you
purchased, the actual shape shall prevail.
• All the functions described are accomplished by the unit, if the unit has no this feature, there is no
corresponding operation happened when press the relative button on the remote controller.
• When there are wide diff erences between Remote Controller Illustration and USERS MANUAL on
function description, the description on USERS MANUAL shall prevail.
• The device could comply with the local national regulations. In Canada, it should comply with
CAN ICES-3(B)/NMB-3(B). In USA, this device complies with part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including interference that may
cause undesired operation.
• This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
-
Reorient or relocate the receiving antenna.
-
Increase the separation between the equipment and receiver.
-
Connect the equipment into an outlet on a circuit diff erent from that to which the receiver is
connected.
-
Consult the dealer or an experienced radio/TV technician for help.
-
Changes or modifi cations not approved by the party responsible for compliance could void
suers authority to operate the equipment.
