– 22 –
CAUTION
• Exposure of unit or water or other moisture before installation will result in an electrical short.
Do not store in a wet basement or expose to rain or water.
• After unpacking the unit, examine it carefully for possible damage.
• Do not install in a place that can increase the vibration of the unit. Do not install in a place that can amplify
the noise level of unit or where noise and discharged air might disturb user’s neighbors.
• To avoid personal injury, be careful when handling parts with sharp edges.
• Please read the installation manual carefully before installing the unit. It contains further important
instructions for proper installation.
UK Plugs and Sockets etc (Safety) Regulations 1994
SI Number 1768
With regard to Schedule 3, Item 7 of the above UK Regulations, this appliance must be permanently connected
to the fixed wiring of the main electrical supply by means other than the use of an approved 13 Amp plug-top
as outlined in the Regulations.
Electrical work must be carried by suitably qualified persons and in accordance with all relevant safety standards
and codes of practice.
We recommend that the power supply for this appliance is derived from a suitably protected dedicated circuit.
(for U.K. only)
For to comply with the specification 61000-3-3 the local power authority has to be conducted for permit of
operation. The installation condition has to be done as following :
• Installation only by authorized installer
• This product has to be connected to the mains supply via a separate connection to the main distribution box
(circuit breaker box).
Summary of Contents for RAS-10SAH-E
Page 51: ... 51 9 4 2 PC Board Layout Bottom View Top View ...
Page 62: ......
