6
EN
Batteries
• To replace the batteries, use two new batteries (AAA type).
• The batteries will last about one year under normal usage.
• Replace the batteries if there is no receiving beep from the indoor unit or when the air conditioner cannot be operated using the
remote controller.
• To avoid malfunctions due to battery leakage, remove the batteries when not using the remote controller for over one month.
• Slide off the cover while pressing the sides.
• Battery replacement
Be careful not to reverse the (+) position and the (–) position.
Setting the clock
Before you start operating the air conditioner, set the clock of the remote controller using
the procedures given in this section. The clock panel on the remote controller will
indicate the time regardless of whether the air conditioner is in use or not.
Initial setting
When batteries are inserted in the remote controller, the clock panel displays AM 0:00
and flashes.
a
ON
button
Press the ON
button to set the current time.
Each press of the ON button changes the time in one minute increments.
Holding down the ON button changes the time in ten minute increments.
b
SET
button
Press the SET
button.
The current time is displayed and the clock starts.
Adjusting the clock
a
CLOCK button
Press the CLOCK button.
The clock time indicator flashes.
b
ON
button
Press the ON
button to set the current time.
Each press of the ON button changes the time in
one minute increments.
Holding down the ON button changes the time in ten
minute increments.
c
SET
button
Press the SET
button.
The current time is displayed and the clock starts.
a
b
ON
ON
SET
SET
a
b
c
Push CLOCK
ON
ON
SET
SET
RASseries_OwnersManual.book Page 6 Tuesday, January 9, 2007 4:48 PM
