Toshiba RAS-18J2AVRG-E, Installation Manual

16

OTHERS

OTHERS

Gas Leak Test

Remote Control A-B Selection

To separate using of remote control for each indoor unit in case of 2 air 
conditioner are installed near.

Remote Control B Setup.

1.  Press [RESET] button on the indoor unit to turn the air conditioner ON.
2.  Point the remote control at the indoor unit.
3.  Push and hold [CHECK] button on the Remote Control by the tip of the 

pencil. “00” will be shown on the display (Picture 

1

).

4.  Press [MODE] during pushing [CHECK]. “B” will show on the display 

and “00” will disappear and the air conditioner will turn OFF. The Remote 
Control B is memorized (Picture 

2

).

Note :  1.  Repeat above step to reset Remote Control to be A.
 

2.  Remote Control A have not “A” display.

3.  Default setting of Remote Control from factory is A.

• Check the 

fl

 are nut connections for the gas leak with a gas leak detector 

or soap water.

Check places for
the indoor unit.

Check places for
the outdoor unit.

•  When two indoor units are installed in the same room or adjacent two 

rooms, if operating a unit, two units may receive the remote control signal 
simultaneously and operate. In this case, the operation can be preserved 
by setting either one remote control to B setting. (Both are set to A setting 
in factory shipment.)

•  The remote control signal is not received when the settings of indoor unit 

and remote control are different.

•  There is no relation between A setting/B setting and A room/B room when 

connecting the piping and cables.

1

2

Test Operation

To switch the TEST RUN (COOL) mode, press [RESET] button for 
10 seconds. (The beeper will make a short beep.)

Auto Restart Setting

The product was shipped with Auto Restart function in the off position. 
Turn it on as required.

This product is designed so that, after a power failure, it can restart automatically 
in the same operating mode as before the power failure.

Information

     How to set the Auto Restart

1.  Press and hold the [RESET] button on the indoor unit for 3 seconds to 

set the operation. (3 beep sound and OPERATION lamp blink 5 time/sec 
for 5 seconds)

2.  Press and hold the [RESET] button on the indoor unit for 3 seconds to 

cancel the operation. (3 beep sound but OPERATION lamp does not 
blink)

  •  In case of ON timer or OFF timer are set, AUTO RESTART 

OPERATION does not activate.

OPERATION / 
RESET Button