These are not failures
In this case
Description and where to check
Operation lamp
Operation lamp (green) is blinking slowly.
It is not a fault
•
For a power failure during operation (including Timer On setting), the lamp illumi-
nates when the power is supplied again. When the button in the remote controller is
pressed once, the operation starts and the blinking changes to illuminate.
Re-select the timer when the power resumes since the timer settings are cancelled
during a power failare.
Operation lamp (green) or timer lamp (orange) blinks
rapidly (5 times per second).
Chec
k a
gain
•
Check the failure in accordance with the procedure “If the lamp in the indoor unit
blinks”.
Page 32
The lamp in the displays of the indoor unit is dark.
•
Is the “Indoor unit displays brightness” set to “Standard”? Bright it by press and hold
SET
for 5 seconds.
•
Is Comfort Sleep operating (when 1, 3, 5 or 9 hours are set)?
Page 19
•
Is it operating in Automatic operation.
Page 11
Remote contr
oller operation
Remote controller transmission cannot be achieved
Indoor unit.
Chec
k a
gain
•
Is the button on the remote controller pressed while the transmission and receiving
portion points at the transmission and receiving portion on the main unit?
Page 10
•
Is it immediately after the operation stops? (A signal is transmitted from the indoor
unit to the remote controller immediately after the operation stops)
Press the button again.
•
Is the direction of the batteries (+, -) correct?
Page 9
•
Are the batteries discharged?
•
Does the “A-B switching” in remote controller match the indoor unit?
Page 34
The vertical direction louvers do not move or
move in a narrow range even when
FIX
FIX
is
pressed.
•
Is timer on booked?
Page 20
•
Is the automatic cleaning operation on?
Page 25
•
The vertical direction louvers may move only in a narrow angle when the humidity in the
room is high during Automatic operation, Cooling or Dehumidifying.
Page 11-14
Setting temperature is not displayed even when
TEMP.
is pressed.
•
Is it set to Picoion air purifi er only?
Page 15
Air conditioner does not stop operating even when
is pressed.
•
Automatic cleaning is operating?
Page 11-12
Press
more 2 times to stop the operation.
35
1110650159_(31-38)_EN.indd 35
1110650159_(31-38)_EN.indd 35
2/28/11 2:11 PM
2/28/11 2:11 PM