FILE NO. SVM-1
401
7
Item
15. Self-Cleaning
function
Operation flow and applicable data, etc.
15-1-1. Self-Cleaning diagram
Description
Operation display
ON
OFF
OFF
FCU fan
ON
ON
OFF
rpm is depend on presetting.
(500RPM)
FCU louver
OPEN
OPEN (12.7º)
CLOSE
Timer display
ON or OFF
ON
ON or OFF
depend on presetting of timer function.
depend on presetting of timer function.
Compressor
ON or OFF
OFF
OFF
depend on presetting per room temperature.
CDU fan
ON or OFF
OFF
OFF
depend on presetting per room temperature.
Cool mode or dry mode
operation more than 10 mins.
Self-Cleaning mode
operate 30 mins.
Automatically turn-off.
Operation time
Turn off by remote controller or
timer-off function.
−
44
−
How to set/cancel Self-Cleaning function
To set/cancel the Self-Cleaning function, proceed as
follows:
15-1-2. Self-Cleaning function release
ON
Operation LED
Self-cleaning
flash 1 Hz
•
function
Timer LED
Flash 1 Hz
OFF flash 1 Hz
not flash
ON
OFF
ON
OFF
•
Setting diagnosis code "06" on remote controlle
(See detail of setting diagnosis code in
1
1
-
4
-1)
Take the remote controller to direction of LED
display on air conditioner, press button up
( ) at
ON
of the remote controller
(Fig.
15
-
1
-2) 1 time to send the code "07"
(within 3 sec. after press [RESET] buton)
,
then
air conditioner will shutdown automatically.
Also,
LED display will show flash follow the able
below.
•
Turn on air conditioner again by remote controller
to confirm setting.
•
Turn on the power supply to air conditioner,
after that press [RESET] button on air conditioner
1 time to turn on the air conditioner (The LED
display will show in
operation LED
) (Fig.
15
-
1
-1)
•
Note) Table above will show current status of
Self-Cleaning function
Set or Cancel Self-Cleaning function by push
the RESET button on air conditioner.
When setting is changed, the sound warning will
alarm "Beep". The setting is changed following
below.
Fig.
15
-
1
-1
Fig.
15
-
1-
2
Temporary switch
