<How to
cutting the Front panel
>
•
To connect piping to the bottom side, the Front
panel must be cut off.
•
The front panel can be removed by removing
2 screws securing then secure remove the front
panel from the main body.
350 mm
350 mm
Coping saw
Half round
fi
le
•
The marking for cutting are indicated on the
inside of the Front panel in the following
positions.
•
Cut off the pipe exist from inside of Front
panel using a coping saw or an equivalent
tool.
•
The plastic burrs from the cutting process
should be removed with a half round file or
an equivalent tool.
CAUTION
When cutting the Front panel, be careful of cutting
tools and any sharp edges of plastic. It can cause
injuries.
<How to
remove the drain hose
>
•
Removed fixing screw of LED set then pull out it
from the main body.
•
Removed 2 screws to fix drain pan then secure
remove the drain pan from the main body.
Drain pan
Screw 2 pcs.
LED set
Screw
•
The drain hose can be removed by removing
the screw securing the drain hose then secure
rotate steel plate of drain hose to out of the
Drain pan and pulling out the drain hose.
Screwdriver
Screw
Steel plate
of drain hose
Drain hose
<
How to fix the drain hose
>
•
To install the drain hose, insert the drain hose
firmly until the connection part contacts with
heat insulator, secure push steel plate of drain
hose to predetermined position of Drain pan
then fix it by original screw.
CAUTION
When removing or install the drain hose, be
careful of any sharp edges of steel plate. The
edges can cause injuries.
Fig. 10-3-
9
Fig. 10-3-
10
Fig. 10-3-
1
1
Fig. 10-3
-1
2
Fig. 10-3-
1
3
Main body
Front panel
Screw 2 pcs.
Fig. 10-3-
8
Be careful of air inlet grill fall down that may cause
of injure of part damage.
Air inlet grille
- 71 -
