– 70 –
9-3-2. Cancel the Auto Restart Function
To cancel auto restart function, proceed as follows :
Repeat the setting procedure : the unit receives the signal and beeps 3 times.
The unit will be required to be turned on with the remote controller after the main power supply is turned off.
• When the system is on stand-by (not operating)
• When the system is operating
9-3-3. Power Failure During Timer Operation
When the unit is turned off because of power failure during timer operation, the timer operation is cancelled.
In that case, set the timer operation again.
NOTE
The Everyday Timer is reset while a command signal can be received from the remote controller even if it
stopped due to a power failure.
Operation
Push [RESET] button for more than
3 seconds. (Less than 10 seconds)
Motions
The unit is on standby.
p
(Push [RESET] button for more than 3 seconds.)
The unit starts to operate.
The green indicator is on.
p
After approx. 3 seconds,
The unit beeps 3 times and continues to operate.
If the unit is not required to operate at this time, push [RESET]
button once more or use the remote controller to turn it off.
Operation
Push [RESET] button for more than
3 seconds. (Less than 10 seconds)
Motions
The unit is in operation.
The green indicator is on.
p
(Push [RESET] button for more than 3 seconds.)
The unit stops operating.
The green indicator is turned off.
p
After approx. 3 seconds,
The unit beeps 3 times.
If the unit is required to operate at this time, push [RESET] button
once more or use the remote controller to turn it on.
