11
EN
ENGLISH
FR
ANÇAIS
DEUTSC
H
IT
ALIANO
ESP
AÑOL
ǼȁȁǾȃǿȀǾ
POR
TUGUÊS
#
##SW###
#
##R
U#
##
High power (Hi POWER)
• The Hi POWER (high power operation) mode automatically controls room temperature,
air flow and the operation mode so that the room is quickly cooled in summer and
warmed in winter. (
)
see page 16.)
Setting Hi POWER mode
a
Hi POWER button
Press the Hi POWER button. The Hi POWER mark on the remote control is shown.
Canceling Hi POWER mode
a
Hi POWER button
Press the Hi POWER button once again.
The Hi POWER mark on the remote control turns off.
ON timer and OFF timer
Setting the ON Timer
a
ON
button
Press the ON
button. Set the timer to the desired time.
Each time the ON button is pressed, the time changes in ten minute increments.
Holding down the ON button changes the time in one hour increments.
b
SET
button
Press the SET
button to set the timer.
The timer time is displayed, and the timer starts.
c
CLR
button
Press the CLR
button to cancel the timer setting.
Setting OFF Timer
a
OFF
button
Press the OFF
button.
Set the timer to the desired time.
Each time the OFF button is pressed, the time changes in ten minute increments.
Holding down the OFF button changes the time in one hour increments.
b
SET
button
Press the SET
button to set the timer.
The timer time is displayed, and the timer starts.
c
CLR
button
Press the CLR
button to cancel the timer setting.
.
Once you select timer operation mode, the settings are saved in the remote control.
Thereafter, the air conditioner will start operating under the same conditions as if you pressed the
or
button of the remote
control.
You cannot set the timer when the clock display is flashing.
Follow the instructions in the section “Setting the clock” on page 6 to set the clock, and then set the timer.
Hi POWER OPERATION
CAUTION
The Hi POWER mode cannot be activated during DRY operation and FAN ONLY
operation (cooling-only models only).
TIMER OPERATION
CAUTION
• When you select timer operation, the remote control automatically transmits the timer signal to the indoor unit at the
specified time. Therefore, keep the remote control in a location where it can transmit the signal to the indoor unit properly.
• If you do not press the SET
button within 30 seconds after setting the time, the setting will be cancelled.
AUTO
PRESET
CLOCK
CHECK
RESET
CLR
SET
SWING
FIX
FAN
ON
OFF
a
PURE
MODE
HiPOWER
ECO
MEMO
SLEEP
TEMP
1.3.5.9H
AUTO
PRESET
CLOCK
CHECK
RESET
CLR
SET
SWING
FIX
FAN
ON
OFF
b
c
a
PURE
MODE
HiPOWER
ECO
MEMO
SLEEP
TEMP
1.3.5.9H
ON
ON
SET
SET
CLR
CLR
OFF
OFF
SET
SET
CLR
CLR
SET
ON
OFF
Summary of Contents for RAS-B10GKVP-E
Page 63: ...E075003445 a ...
