– 20 –
AUTOA
AM
PM
CHK
HiPOWER
START/STOP
PRESET
ON
OFF
˚
C
:
AM
PM
:
P
AUTO
MODE
AUTO
FAN
ECO
TIMER
Hi-POWER
SWING
MEMO
FIX
FILTER
RESET CLOCK CHECK
ON
OFF
SET
CLR
1
6
4
11
3
5
10
7
12
2
9
8
13
14
B
8-6. Remote Controller
8-6-1. Parts Name of Remote Controller
1
START/STOP button
Push the button to start operation.
(A receiving beep is heard.)
Push the button again to stop operation.
(A receiving beep is heard.)
If no receiving sound is heard from the indoor
unit, push the button twice.
2
Mode select button (MODE)
Push this button to select a mode.
Each time you push the button, a mode is
selected in a sequence that goes from
A : Auto changeover control, : Cool,
: Dry,
: Heat (For Heat pump model only),
: Fan only (For Cooling only model), and back
to A. (A receiving beep is heard.)
3
Temperature button
... The set temperature is increased up to 30°C.
... The set temperature is decreased to 17°C.
(A receiving beep is heard.)
4
Fan speed button (FAN)
Push this button to select fan speed. When you
select AUTO, the fan speed is automatically
adjusted according to the room temperature.
You can also manually select the desired fan
speed among five settings.
(LOW , LOW
+
, MED
, MED
+
,
HIGH
) (A receiving beep is heard.)
5
Off timer button (OFF)
Push this button to set the OFF timer.
6
On timer button (ON)
Push this button to set the ON timer.
7
Reserve button (SET)
Push this button to reserve time settings.
(A receiving beep is heard.)
8
Cancel button (CLR)
Push this button to cancel ON timer and OFF
timer. (A receiving beep is heard.)
9
High power button (Hi-POWER)
Push this button to start the high power opera-
tion.
CAUTION
• When pushing the “SWING”, “FIX” and “FILTER”
buttons, indoor unit does not operate and the
receiving beep sound also not appear.
10
Memory button (MEMO)
Push this button to stand by memorizing the
settings.
Push the button again for more than 4 seconds
to memorize the setting indicated on the
remote controller and
P
mark is indicated.
(Refer to “MEMORY/PRESET OPERATION”)
11
ECO timer button (ECO)
Push this button to start the ECO timer (OFF
timer) operation.
You can select the OFF timer time among
four settings (1, 3, 5 or 9 hours).
12
PRESET button
Push this button to operate the air conditioner
according to settings memorized by the
MEMO button.
13
TIMER button
Use this button to change the clock, ON
timer, and OFF timer times.
To forward the time, push the “TIMER ”
button.
To set back the time, push the “TIMER ”
button.
14
Automatic operation button (AUTO)
Push this button to operate the air conditioner
automatically. (A receiving beep is heard.)
(Refer to “AUTOMATIC OPERATION”)
Fig. 8-6-1
Summary of Contents for RAS-M10YDCV-E
Page 62: ......
