30-EN
29-EN
– 15 –
Releasing the louver lock
Adjusting the horizontal direction
1
Push and hold the
and “TEMP.
”
buttons for at least 4 seconds while running is
stopped.
blinks.
“01” appears in CODE No.
2
Push the
button (left side of the button)
to select a unit
The unit number changes each time you push the
button.
UNIT No.
1-1
UNIT No.
2-1
UNIT No.
3-1
UNIT No.
4-1
No
display
The fan of the selected unit runs, and the louver
swings.
3
Push the “TEMP.
” buttons to change
the CODE No. to “45”.
4
Push the “TIME
” buttons to select a
direction.
Direction SET
DATA
Direction setting
“0000”
Smudging reduction position
(reduces ceiling smudging)
“0002”
Cold draft position
(Less directly expose your body to
cool air)
(factory default)
5
Push the
button to check the settings.
The indicator stops blinking and stays lit, and the
settings are confirmed.
6
Push the
button to
fi
nish the setting.
*
If the cold draft position is selected, the ceiling
smudging reduction effect will be reduced.
Set “0000” in Step 4 of “Setting the louver lock”.
The mark disappears.
*
Steps 1 - 3 and 5, 6 of “Setting
the louver lock” also apply to
releasing the lock.
SET DATA
0000
WARNING
Cleaning the air
fi
lter and other parts of the air
fi
lter involves dangerous work in high places, so be sure to
have a quali
fi
ed installer or quali
fi
ed service person to do it.
Do not attempt it by yourself.
After the cooling or dry auto (cooling) operation has
fi
nished, the dry operation is performed and the fan
starts running. When cleaning the unit, stop the drying operation forcibly and turn off the circuit breaker
to avoid electric shock.
Cleaning air
fi
lters
Clogged air fi lters will reduce the cooling and heating performance.
(1) If “ ” is displayed on the remote controller, clean the air fi lters.
(2) When the cleaning of air fi lters has been completed, push
button.
“ ” disappears.
When the unit will not be used for a long time
1. Perform the fan operation for a couple of hours to dry inside.
2. Press
on the remote controller to stop running, and turn off the circuit breaker.
3. Clean the air fi lters and reinstall them.
Before the cooling season
Clean the drain pan
•
Contact the dealer where you purchased the product.
(Drain does not work if the drain pan or vent is clogged. In some cases the drain may overflow and wet the wall or floor.
Be sure to clean the drain pan before the cooling season.)
(1)
(2)
10
Maintenance
OM_1115350244_EN.indd 15
OM_1115350244_EN.indd 15
5/7/2564 13:31:05
5/7/2564 13:31:05
