1
Push
SET
+
CL
+
TEST
buttons simultaneously
for 4 seconds or more.
2
(
←
←
←
←
←
Line address)
Using the temperature setup
/
buttons,
set
to the CODE No.
3
Using timer time / buttons, set the line address.
4
Push
SET
button.
(OK when display goes on.)
5
(
←
←
←
←
←
Indoor unit address)
Using the temperature setup
/
buttons, set
to the CODE No.
6
Using timer time / buttons, set 1 to the line address.
7
Push
SET
button.
(OK when display goes on.)
8
(
←
←
←
←
←
Group address)
Using the temperature setup
/
buttons, set
to the CODE No.
9
Using timer time / buttons, set
to Individual,
to Master unit, and
to sub unit.
10
Push
SET
button.
(OK when display goes on.)
11
Push
TEST
button.
Setup completes. (The status returns to the usual stop status.)
10-5. Confirmation of Indoor Unit No. Position
1. To know the indoor unit addresses though position of the indoor unit body is recognized
• In case of individual operation (Wired remote controller : indoor unit = 1 : 1)
(Follow to the procedure during operation)
<Procedure>
1
Push
ON / OFF
button if the unit stops.
2
Push
UNIT LOUVER
button.
Unit No.
is displayed on LCD.
(It disappears after several seconds.)
The displayed unit No. indicate line address and
indoor unit address.
(When other indoor units are connected to the
identical remote controller (Group control unit), other
unit numbers are also displayed every pushing
UNIT LOUVER
button.
- 90 -
