Toshiba RAV-GM901BTP-E, Installation Manual

– 23 –

„

When a test run is not 
performed properly

y

When a test run is not performed properly, refer 
to the error code and the part to be checked on 
“Troubleshooting”.

y

When a test run is executed before installing the 
external duct, a protection control may be activated 
and lets the unit stop and the code P12 may be 
displayed. (This is not due to a malfunction but to the 
current control function of the DC motor in this unit.) 
When a test run executed before installing the 
external duct, select “Low” for the fan speed level or 
cover the air discharge.

y

In addition, stop the operation before replacing the 
High-ef

fi

 ciency 

fi

 lter or opening the service panel.

After the test run, reset the circuit breaker of the 
indoor unit.

Wired remote controller

1

When TEMPORARY button is pushed for 10 
seconds or more, “Pi!” sound is heard and the 
operation changes to test run. After approx. 
3 minutes, a cooling operation starts forcedly.

Check cool air starts blowing. If the operation 
does not start, check wiring again.

2

To stop a test operation, push TEMPORARY 
button once again (Approx. 1 second).

Check wiring / piping of the indoor and outdoor 
units in test run.

TEMPORARY button

11

Maintenance

<Daily maintenance>

4

 Cleaning of the air 

fi

lter

If   is displayed on the remote controller, maintain the air 

fi

lter.

3

1,2

1

Push the 

 button to stop the operation, then 

turn off the circuit breaker.
After the cooling or dry operation, the fan keeps 
running for self-cleaning. Push the 

 button 

twice to stop the operation.

1. Take out the air 

fi

lter.

y

Slide and remove the 

fi

lter as shown in the following 

fi

gure:

 WARNING

When the 

fi

rst 

fi

lter comes out without connected to the other one, insert it once more to connect the two 

fi

lters 

together and pull out them as connected. Do not insert hands to take out the second 

fi

lter. You may injure 

yourself.

2. Cleaning with water or vacuum cleaner.

y

If dirt is heavy, clean the air 

fi

lter by tepid water with neutral detergent or water.

y

After cleaning with water, dry the air 

fi

lter suf

fi

ciently in a shade place.

3. Mount the air 

fi

lter.

* Insert the 

fi

lters into the direction which the arrows, carved on the 

fi

lters, show. (2 

fi

lters are identical)

2

Turn on the circuit breaker, then push the

button on the remote controller to start the 

operation.

3

After cleaning, push  .

 display disappears.

 CAUTION

y

Do not start the air conditioner while leaving air 

fi

lter removed.

y

Push the 

fi

lter reset button. (   indication will be turn off.)

46-EN

45-EN