– 16 –
Remote controller wiring
Strip off approx. 9 mm the wire to be connected.
Wiring diagram
A
B
A
B
Terminal block
Remote
controller
unit
Terminal block for
remote controller
wiring of indoor unit
Remote controller wire
(Locally procured)
8
Applicable controls
REQUIREMENT
• When you use this air conditioner for the first time, it
takes approx. 5 minutes until the remote controller
becomes available after power-on. This is normal.
<When power is turned on for the first time after
installation>
It takes
approx. 5 minutes
until the remote controller
becomes available.
<When power is turned on for the second (or later)
time>
It takes
approx. 1 minute
until the remote controller
becomes available.
• Normal settings were made when the indoor unit was
shipped from factory.
Change the indoor unit settings as required.
• Use the built-in remote controller to change the
settings.
* The settings cannot be changed using the
wireless remote controller, simplified wired
remote controller, or remote-controller-less
system (for central remote controller only).
Basic procedure for changing
settings
Change the settings while the air conditioner is not
working.
(Stop the air conditioner before making
settings.)
CAUTION
Set only the “Code(DN)
ˮ
shown in the following table: Do
not set any other “Code(DN)
ˮ
.
If a “Code(DN)
ˮ
not listed is set, it may not be possible to
operate the air conditioner or other trouble with the
product may result.
1
Push the [
MENU] button to display the
menu screen.
2
Push and hold the [
MENU] button and
the [
∨
] button at the same time to
display the “Field setting menu”.
Push and hold the buttons for more than 4
seconds.
Power on
“ Setting”
flashes
“ Setting”
goes out
Remote
controller is
available
Approx. 5 minutes
Power on
“ Setting”
flashes
“ Setting”
goes out
Remote
controller is
available
Approx. 1 minutes
6. Setting timer operation mode
7. DN setting
8. Reset power consumption data
Field setting menu(2/2)
Return
Set
31-EN
32-EN
