– 36 –
Setting the louver lock
1
Push and hold the
button (right side of
the button) for at least 4 seconds while
running is stopped.
blinks.
• When no unit number is displayed, all units are
selected.
2
Push the
button (left side of the button)
to select a unit.
The unit number changes each time you push the
button.
The fan of the selected unit runs, and the louver
swings.
3
Push the “TEMP.
” buttons to
display the number of the louver to fix its
direction.
The selected louver swings.
4
Push the
buttons to select the
direction of the louver you do not want to
swing.
* If (4) or (5) is selected, condensation may occur
during cooling.
5
Push the
button to confirm the setting.
When the setting is confirmed, the
mark lights
up.
(To set the louver lock of another unit, repeat from
Step 2. To set another louver lock of the same unit,
repeat from Step 3.)
6
Push the
button to finish the setting.
* F1 appears in the CODE No. section on the
remote controller. This indicates that the louver
01 shown in the following figure is selected.
NOTE
Even in louver lock mode, the louver temporarily
moves in the following cases:
• When the air conditioner is stopped
UNIT LOUVER
Unit No.
1-1
Unit No.
2-1
Unit No.
3-1
Unit No.
4-1
(1)
0001
(2)
0002
(3)
0003
(5)
0005
(4)
0004
0001 - 0005
(Louver position
code)
Louver No.
03
01
02
04
Refrigerant
pipe
Drain pipe
Electrical control box
Releasing the louver lock
Set “0000” in Step 4 of “Setting the louver lock”.
The
mark disappears.
* Steps 1 - 3 and 5, 6 of “Setting
the louver lock” also apply to
releasing the lock.
◆
Adjusting the horizontal direction
1
Push and hold the
and “TEMP.
”
buttons for at least 4 seconds while running
is stopped.
blinks.
“01” appears in CODE No.
2
Push the
button (left side of the button)
to select a unit
The unit number changes each time you push the
button.
The fan of the selected unit runs, and the louver
swings.
3
Push the “TEMP.
” buttons to
change the CODE No. to “45”.
4
Push the “TIME
”buttons to select a
direction.
5
Push the
button to check the settings.
The indicator stops blinking and stays lit, and the
settings are confirmed.
6
Push
button to finish the setting.
* If the cold draft position is selected, the ceiling
smudging reduction effect will be reduced.
Direction SET
DATA
Direction setting
“0000”
Smudging reduction position
(reduces ceiling smudging)
“0002”
Cold draft position
(Less directly expose your body to
cool air)
(factory default)
0000
SET DATA
Unit No.
1-1
Unit No.
2-1
Unit No.
3-1
Unit No.
4-1
No
display
71-EN
72-EN
