42-EN
41-EN
– 21 –
[Procedure example]
Manual address setup procedure
While the operation stops, change the setup.
(Stop the operation of the unit.)
2,6
1
7
3
-1,
4
5
6
-1,
-1,
7
3
-3,
4
-3,
3
-2,
4
-2,
5
-2
5
-3,
1
Push + + buttons simultaneously
for 4 seconds or more. After a while, the
display part
fl
ashes as shown below. Check
the displayed CODE No. is [10].
When the CODE No. is other than [
10
], push
button to clear the display and repeat procedure
from the
fi
rst step.
(After pushing
button, operation of the remote
controller is not accepted for approx. 1 minute.)
(For a group control, No. of the
fi
rstly displayed
indoor unit becomes the header unit.)
(* Display changes according to
the model No. of indoor unit.)
2
Every time
button is pushed, the
indoor UNIT No. in the group control is
displayed in order. Select the indoor unit of
which setup is changed.
In this time, the position of the indoor unit of which
setup is changed can be con
fi
rmed because fan
of the selected indoor unit operate.
3
1. Specify CODE No. [
12
] with TEMP.
/
buttons.
(CODE No. [
12
]: Line address)
2. Change the line address from [
3
] to [
2
] with TIME
/
buttons.
3. Push
button.
In this time, the setup
fi
nishes when the display
changes from
fl
ashing to lighting.
Indoor UNIT No. before setup change is displayed.
4
1. Specify CODE No. [
13
] with TEMP.
/
buttons.
(CODE No. [
13
]: Indoor address)
2. Change the indoor address from [
3
] to [
2
] TIME
/
buttons.
3. Push
button.
In this time, the setup
fi
nishes when the display
changes from
fl
ashing to lighting.
Indoor UNIT No. before setup change is displayed.
5
1. Specify CODE No. [
14
] TEMP.
/
buttons.
(CODE No. [
14
]: Group address)
2. Change the SET DATA from [
0001
] to [
0002
] TIME
/
buttons.
(SET DATA [Header unit:
0001
] [Follower unit:
0002
])
3. Push
button.
In this time, the setup
fi
nishes when the display
changes from
fl
ashing to lighting.
Indoor UNIT No. before setup change is displayed.
6
If there is other indoor unit to be changed,
repeat procedure
2
to
5
to change the
setup.
When the above setup has
fi
nished, push
to select the indoor UNIT No. before
change of setup, specify CODE No. [12],
[13], [14] in order with TEMP.
/
buttons, and then check the changed
contents.
Address change check
Before change: [
3-3-1
]
→
After change: [
2-2-2
]
Pushing button clears the contents of which
setup was changed.
(In this case, procedure from
2
is repeated.)
Indoor UNIT No. before setup change is displayed.
7
After check of the changed contents, push
button. (Setup is determined.) When
button is pushed, the display disappears
and the status becomes the normal
stopped state. (When button is pushed
the operation from the remote controller is
not accepted for approx. 1 minute.)
y
If the operation from the remote controller is
not accepted even 1 minute or more passed
after pushing button, it is considered that the
address setup is incorrect.
In this case, the automatic address must be
again set up.
Therefore repeat procedure of the setup change
from the Procedure
1
.
