TOSHIBA 1075000646_EN
5
EN
NAMES AND FUNCTIONS OF INDICATIONS ON WIRELESS
REMOTE CONTROL
Display
All indications, except for clock time indication, are indicated by pressing the START/STOP button.
1
1
1
1
1
Transmission mark
This transmission mark (
,
) indicates when the remote control transmits signals to the indoor unit.
2
2
2
2
2
Mode display
Indicates the current operation mode.
(AUTO : Automatic control, A : Auto changeover control,
: Cool,
: Dry,
: Heat,
: Fan only)
3
3
3
3
3
Temperature display
Indicates the temperature setting (17
°
C to 30
°
C).
When you set the operating mode to
: Fan only, no temperature
setting is indicated.
4
4
4
4
4
FAN speed display
Indicates the selected fan speed. AUTO or one of five fan speed levels
(LOW
, LOW
+
, MED
, MED
+
,
HIGH
) can be indicated.
Indicates AUTO when the operating mode is either AUTO or
: Dry.
5
5
5
5
5
TIMER and clock time display
The time set for timer operation or clock time is indicated.
The present time is always indicated except for TIMER operation.
6
6
6
6
6
Hi POWER display
Indicates when the Hi POWER operation starts.
Press the Hi POWER button to start and press it again to stop the
operation.
7
7
7
7
7
(MEMORY) display
Flashes for 3 seconds when the MEMO button is pressed during
operation.
mark is indicated when keeping the button depressed for more than
3 seconds while the mark is flashing.
Press another button to turn off the mark.
8
8
8
8
8
ECO TIMER display
Indicates when the ECO TIMER is in operation.
Each time you press the ECO button, the display changes in the sequence of 1, 3, 5 or 9h.
•
In the illustration, all indications
are indicated for explanation.
During operation, only the
relevant indications will be
indicated on the remote control.
Loading the remote control batteries.
1
1
1
1
1
Remove the cover, and insert the
batteries.
2
2
2
2
2
Press the RESET button.
The clock display flashes.
Adjust the clock.
Place back the cover.
Batteries
•
To replace the batteries, use two new batteries (AAA type).
•
In normal use, the batteries will last about one year.
•
Replace the batteries if there is no receiving beep from the
indoor unit or when the air conditioner cannot be operated using
the remote control.
•
To avoid malfunctions by battery leakage, remove the batteries
when not using the remote control for more than one month.
PREPARATION AND CHECK BEFORE USE
•
Slide off the cover while
pressing the sides.
•
Battery replacement
Be careful not to reverse the
(+) position and the (–)
position.
A
B
AUTOA
8 6
5
4
3 1
7
2
A
B
AUTO
1
FAN
MODE
Hi-POWER
ON
OFF
SET
CLR
ECO
AUTO
TIMER
CLOCK CHECK
RESET
FILTER
FIX
SWING
MEMO
2
01(EN)_1075000646 P03-07
7/16/04, 13:33
5
3
