– 7 –
7
(PRESET) display
Indicated when memorizing the preferred
operation mode or when it has been memorized.
Also, this icon is indicated when the memorized
preferred operation is displayed.
8
(COMFORT SLEEP) display
Indicated during the OFF timer operation that
automatically adjusts the room temperature and
the fan speed. Each time you press the
COMFORT SLEEP button, the display changes in
the sequence of 1h, 3h, 5h, and 9h.
9
(QUIET) display
Indicated during the quiet operation.
10
Swing display
Indicated during the swinging operation where the
horizontal louver automatically moves up and
down.
NOTE
When both wired remote controller and wireless remote
controller are used, display on the screen of wireless
remote controller may differ from the actual operation in
some cases.
Preparation and check before
use
◆
Loading batteries
1
Remove the battery cover.
2
Insert 2 new batteries (R03 [AAA]) following
the (+) and (-) positions.
◆
Batteries
• To replace the batteries, use two new batteries (R03
[AAA]).
• In normal use, the batteries will last about one year.
• Replace the batteries if there is no receiving beep
from the indoor unit or when the air conditioner
cannot be operated using the remote controller.
• To avoid malfunctions by battery leakage, remove
the batteries when not using the remote controller for
more than one month.
A
C
L
4-2. Adjusting clock
◆
Setting the clock
Before you start operating the air conditioner, set the
clock of the remote controller using the procedures
given in this section. The clock panel on the remote
controller will indicate the time regardless of whether
the air conditioner is in use or not.
Initial setting
When batteries are inserted in the remote controller the
clock panel will indicate AM 0:00 and will flash.
1
TIMER or button
Press the TIMER or button to set the current
time.
Each press of the TIMER button changes the time
in one minute steps.
Pressing the TIMER button continually changes
the time in ten minute steps.
2
SET
button
Press the SET
button.
The current time is indicated and the clock starts.
Clock adjusting
1
CLOCK button
Press the CLOCK by tip of a pencil.
The CLOCK display flashes.
2
TIMER
or
button
Press the TIMER or button to set the current
time.
Each press of the TIMER button changes the time
by one minute.
Pressing the TIMER button continually changes
the time by ten minutes.
3
SET
button
Press the SET
button.
The current time is indicated and the clock starts.
PRESET
QUIET
SWING
TIMER
ON
FILTER
CHK
CLOCK
OFF
CLR
SLEEP
SET
FIX
H
i-POWER
COMFORT
SLEEP
MODE
TEMP
FAN
2
1
ON
OFF
ON
OFF
SET
SET
PRESET
QUIET
SWING
TIMER
ON
FILTER
CHK
CLOCK
OFF
CLR
SLEEP
SET
FIX
Hi-POWER
COMFORT
SLEEP
MODE
TEMP
FAN
3
2
1
ON
OFF
ON
OFF
SET
SET
13-EN
14-EN
+001111055901_01EN.book Page 7 Monday, September 5, 2011 2:23 PM
