9
EN
ENGL
ISH
FRANÇAI
S
DEUTSCH
IT
AL
IA
N
O
ESP
AÑOL
ΕΛΛ
Η
ΝΙΚΗ
POR
T
U
G
UÊS
##
#S
W#
#
#
##
#R
U##
#
Location of the remote controller
• Keep the remote controller where its signals can reach the receiver on the
panel. (maximum distance is 7 m)
• When you select the timer operation, the remote controller automatically
transmits a signal to the indoor unit at the specified time.
If you keep the remote controller in a position that hinders proper signal
transmission, a time lag of up to15 minutes may occur.
Remote controller holder
Installing the remote controller holder
• Before you install the remote controller holder on a wall or pillar, check
whether the remote controller signals can be received by the indoor unit.
Mounting and removing the remote controller
• To mount the remote controller, hold it parallel to the remote controller holder
and push it in fully.
To remove the remote controller, slide the remote controller upwards and
take it out from the holder.
HANDLING THE REMOTE CONTROLLER
CAUTION
• The air conditioner will not operate if curtains, doors or other materials are blocking the signals sent from the remote controller
to the indoor unit.
• Prevent any liquid from falling onto the remote controller.
• If the infrared signal receiver on the switch panel is exposed to direct sunlight, the air conditioner may not function properly.
Use curtains to prevent direct sunlight being exposed to the receiver.
• If the air conditioner is installed in a room which has fluorescent lights with electronic starters or inverter systems, signals may
not be properly received and the air conditioner cannot start or stop while the lights are on.
If you plan to use the fluorescent lights in the same room where the air conditioner operates, consult your local dealer.
• If other electrical appliances react to the remote controller of the air conditioner, either remove these appliances or consult your
local dealer.
Receiver section of
main unit
Transmitting section of
remote controller
Approx. 7m
Receiver section of main unit
When the receiver section receives the signal,
the receiver at the indoor unit sounds.
pip, pip
: Operation
Long pip
: Stop
pip
: Change
AMP Air Conditioning
www.ampair.co.uk | sales@ampair.co.uk
