Wireless Remote Controller Kit
Owner’s Manual
– 13 –
11
Emergency Operation
In the event of an emergency shown below, push emergency operation on the signal
receiving part (inside the ceiling panel or indoor unit) for emergency operation.
• The batteries of the remote controller have been exhausted.
• The remote controller is out of order.
• The remote controller has been lost.
1
Start
Push emergency operation.
(When the emergency operation is started at a room temperature of 24°C or more, the air
conditioner enters the cooling mode. When the emergency operation is started at a room
temperature below 24°C, the air conditioner enters the heating mode.)
2
Stop
Push emergency operation once again.
CAUTION
The test run switch in the signal receiving part is used for a test run during the installation
work. Do not use it for other purposes.
1,2
13-EN
Summary of Contents for RBC-AX23UW-E
Page 16: ...EH72394301 ...
