Toshiba RBC-AX23UW-E, Owner'S Manual

Wireless Remote Controller Kit

Owner’s Manual

– 4 –

EN

„

Signal Receiving Part

• The signal receiving part is attached to the 

indoor unit.

• Hereinafter, all remote controller button 

names are indicated with respective 
symbols displayed on the remote 
controller.

Example: Start/Stop button 

→

1

Emergency operation button 
(See page 13)

2

Signal receiver

Receives signals from the remote controller.

3

Display lamp

Any of these lamps flashes while an error 
occurs.
When an lamps flashes, see “Before Asking 
for Repair Work” on page 14.

4

 lamp (green)

This lamp illuminates when unit is on.

5

 lamp (green)

This lamp illuminates while the timer is 
reserved.

6

lamp (orange)

• Illuminates in the heating mode at the 

beginning of operation or during defrosting 
or when the temperature controller is 
activated.

• Flashes during an error state.

The rear of signal receiving part

The following switches are provided on the 
rear of the signal receiving part. For their 
settings, contact the dealer from whom you 
purchased the air conditioner.
•

Header/follower switch

Normally, set this switch to “HEADER” to 
use the remote controller as a header.
The remote controller can be used 
together with the wired remote controller 
(sold separately).

•

Test run switch

Do not use this switch in normal operation, 
but use for service.

•

Address switches (See page 12)

Distinguish transmit signals and receive 
signals.

CAUTION

• If beep is heard with the 

 lights and the 

 and 

 flashing alternately while the 

heat-pump type air conditioner is used, 
desired operation mode is disabled. The 
same is true if the AUTO mode is 
selected in a model that is not provided 
with the cool/heat auto function.

• Even if you push 

, 

 or   when 

remote controller operation is disabled 
by the central control or other means, “pi” 
is heard 5 times and the button operation 
is not accepted.

2

6

3

1

4

5

4-EN