Wireless Remote Controller Kit
Owner’s Manual
– 8 –
EN
4
Timer Operation
• After the timer has been set, put the
remote controller at a position where
signals of the remote controller can reach
the signal receiver on the indoor unit. The
timer operation signal is transmitted from
the remote controller.
• Set the timer while an operation mode is
displayed as follows:
Timer period
The setup time increases by 0.5 hours
(30 minutes) each time you push
.
The maximum setup time is 72.0 hours.
The setup time decreases by 0.5 hours
(30 minutes) each time you push
.
The minimum setup time is 0.5 hours.
Timer display
Each time you push Timer
, the timer
display changes as follows:
<Usage Examples>
▼
Setting OFF timer
(Example) To stop operation in
30 minutes
1
Push Timer
.
and the time flash on the display.
2
Set the time to 0.5 with TIME
or
.
3
Push
.
and the time stop
flashing.
▼
Setting repeat OFF timer
(Example) To stop operation in every
2.5 hours
1
Push Timer
twice.
and the time flash on the display.
2
Set the time to 2.5 with TIME
or
.
3
Push .
and
the
time
stop
flashing.
The OFF timer is activated and the operation
stops in 2.5 hours. When you push
again
to restart the operation, it stops in 2.5 hours.
▼
Setting ON timer
(Example) To start operation in 8 hours
1
Push Timer
three times.
and the time flash on the display.
2
Set the time to 8.0 with TIME
or
.
3
Push .
The operation mode disappears, and
and the time stop flashing.
▼
Canceling timer operation
Push
. The timer display disappears.
Use the timer in the following
cases
Mode
displayed
To stop the air conditioner
when the preset time has
passed
OFF
timer
To stop the air conditioner
each time when the
preset time has passed
Repeat
OFF
timer
To operate the air
conditioner when the
preset time has passed
ON timer
ADR
No display
8-EN
Summary of Contents for RBC-AX23UW-E
Page 16: ...EH72394301 ...
