7
Using the Controls
Whilst all the necessary adjustments and controls for the television are made using the remote control, the
buttons on the television may be used for some functions.
To alter the volume press
—
j
+
.
To alter the programme position press
ee
F
ff
.
Press
MENU
and
S
,
R
,
Q
or
P
to control the sound and
picture options.
Press
MENU
to finish.
When connecting sound equipment to
EXT3
, connect the
audio output of the equipment to the phono sockets on the
television.
To select the external input, press
B
and select the
required input source.
Please always refer to the owner’s manual of the
equipment to be connected for full details.
Please note:
Inserting the headphone plug will mute the
sound from all speakers.
Switching On
Using the Controls
RETURN
OK
Standby
GREEN LED – On Timer Set
(LED 2)
ORANGE LED – Programme Timer Set (
digital
only)
RED LED – Programme Timer Active (
digital
only)
(LED 3)
RED LED – Standby
GREEN LED – Power on
(LED 1)
Headphone jack
Press the
MENU
button on the remote control to see
the menus.
The menu appears as a list of five topics. As each symbol is
selected by pressing
z
or
x
on the navigation ring on the
remote control, its respective options will appear below.
IMPORTANT:
At the bottom of the screen will be a bar
displaying a selection of control functions, i.e. Select,
Watch, Back, Watch TV.
NOTE:
The same menu is displayed in
DTV
(Digital TV)
and
ATV
(Analogue TV) modes, however, where some
items are not available in a mode they will appear
greyed out.
To use the options press the
f
and
e
button on the
remote control to move up and down through them and
OK
,
z
ord
x
to select the required choice. Follow the on
screen instructions. The functions of each menu are
described in detail throughout the manual.
Using the Remote Control
COMMON INTERFACE
The Common Interface is for a Conditional Access
Module (CAM). Contact a service provider.
Input 3
(side) will tak
e
priority over
EXT3 (back) if
both connections
are used at the
same time.
☛
If the RED LED is unlit check that the mains plug is
connected to the power supply and press the
i
/
I
POWER
button on the left side of the television. If the picture does
not appear press
i
on the remote control, it may take a
few moments, the GREEN LED will be lit.
To put the television into Standby press
i
on the remote
control. To view the television press
i
again. The picture
may take a few seconds to appear.
NOTE:
When the
i
/
I
POWER switch is turned off, the
digital channel position you previously viewed may not be
memorised in the television memory.
POWER switch
(Full Power
Down Option)
INPUT 3
(EXT3)
USB JPEG VIEWER
This socket has limited
functionality and Toshiba
can take no responsibility
for damage to other
connected equipment.
HDMI4 INPUT
(model dependant)
Q
p
g
