24
RemotEye 4 User Manual – 90988-007
Figure 2-8: RemotRadar Example
3
SETUP
CHECKLIST
The following information is required for first time setup of the RemotEye 4.
NOTE: The RemotEye 4 comes with DHCP enabled by default. If this is the installation method,
then only the MAC address needs to be recorded. See Table 3-1.
RemotEye 4 MAC address
IP Address
Gateway IP Address
Network Mask
SMTP IP Address
NOTE: Although the SMTP IP address is NOT required, it is required for email notification.
1600XP/XPi Only: When installing the RemotEye 4 in a 1600XP/XPi, you will also need the ADMIN
password.
Record the relevant information in the Set-up Checklist, Table 3-1, to facilitate installation and subsequent
troubleshooting.
Table 3-1 Set-up Checklist
Example values shown are factory-provided default values.
Item
Setting
Recorded Setting
1
RemotEye 4 MAC Address (see Figure 3-1)
(Default – 00E0D8
LLMMNN
)
2*
IP Address (Default. – 192.168.1.168 )
3*
Gateway IP Address (Default – 0.0.0.0)
4*
Sub-Network Mask (Default – 255.255.255.0)
5**
SMTP IP Address (Default – 0.0.0.0)
6***
ADMIN Password (Default - ADMIN)
(1600XP/XPi only)
**
* Not required for DCHP (Dynamic Host Configuration Protocol) setup.
** Required for email notifications.
*** Required for 1600XP/XPi Setup
Summary of Contents for RemotEye 4
