E6580938
−
2
−
■
Wiring
Danger
Mandatory
▼
Turn off input power before wiring.
Wait at least ten minutes and check to make sure that the charge lamp (on the inverter
main unit) is no longer lit.
▼
Tighten the screws on the terminal board to specified torque.
If the screws are not tightened to the specified torque, it could lead to fire.
■
■
■
■
About operation
Danger
Prohibited
▼
Do not wipe the body with a wet cloth.
It could lead to electric shocks.
▼
Do not pull on the cable
It could cause damage or error.
■
■
■
■
About disposal of the product
Warning
Mandatory
▼
Dispose of the product as an industrial waste.
Unless it is disposed of as an industrial waste, it will become risks for human
injury.
Notes on use
NOTES
▼
Avoid installation locations that may be subjected to rapid changes in ambient temperature
or/and humidity.
▼
Route the transmission cable separate from the inverter input/output power wiring.
When disconnecting connection cable, make sure to hold its connector with care not to give
unreasonable stress to the cable and the unit.
▼
Separate the SHIELD terminal ground of the RS485 converter unit from those of
the inverter and the motor. It could cause malfunction due to noise.
▼
Since connectors of optional cables have locking pawls for disconnection prevention at the
inverter and the Option Unit, disconnect such a connector while pressing the pawl by finger
for unlocking.
▼
Mount the Option Unit securely on the panel, otherwise it could fall and cause
malfunction or breakdown
▼
Connect an electromagnetic contactor or the like between the inverter and the power
source to secure external control of emergency stop of operation.
Summary of Contents for RS4002Z-0
Page 14: ......
