User’s Manual
3-21
Hardware, Utilities and Options
Installing a memory module
To install a memory module, follow the steps as detailed below:
1. Shut down the computer - make sure the
Power
indicator is off (refer to
section in Chapter 1, Getting Started if
required).
2. Remove the AC adaptor and all cables and peripherals connected to
the computer.
3. Close the display panel.
4. Turn the computer upside down and remove the battery pack (refer to
section in Chapter 6, Power and Power-Up
Modes, if required).
5. Loosen three screws securing the memory module cover in place -
please note that those screws are attached to the cover in order to
prevent them from being lost.
6. Slide your fingernail or a thin object under the cover and lift it off.
Figure 3-4 Removing the memory module cover
Use a point size 0 Phillips screwdriver.
1. Memory module cover
2. Screws
1
2
