Chapter 4 Replacement Procedures
Satellite L730/Satellite 735/Satellite Pro 730 Maintenance Manual (960-Q08)
32
Installing Touch Pad Switch Board, Touch Pad Board and Touch Pad
The following describes the procedure for installing the boards.
1.
Peel off the separator covering on the sensor portion of a new Touch Pad.
NOTE: Do not reuse the touch pad so that it can not be used after peeling off from the
computer. Be sure to stick a new Touch Pad.
When sticking the Touch Pad, be careful not to get the bubbles under the Touch
Pad.
2.
Secure the Touch Pad bracket with SCREW M2.0*3F 4PCS
3.
Connect the Touch Pad FFC to the connector on the Touch Pad.
4.
Mount Touch Pad board.
5.
Connect the other end of Touch Pad FFC to Touch Pad FFC.
6.
Secure the Touch Pad board with SCREW M2.0*2.5F 3PCS
7.
Mount Touch Pad Switch board and secure it with SCREW M2.0*2.5F 2PCS.
8.
Connect Touch Pad Switch Board FFC to the connector on Touch Pad board.