1.
Remove
two mask seals
at the bottom corners of the
display assembly using a pair of fine-tipped tweezers.
2. Remove
two M2.5x6 black flat head screws
securing
the display mask.
3.
There are
23 latches
securing the
display mask
.
Carefully insert your fingers between the mask and the
LCD panel and pry open the latches starting from the
six top latches
, to the
five latches on each right
and
left sides
, ending with the
bottom seven
latches
.
FL INVERTER AND 14.1” LCD REMOVAL
1. Remove
one M2x4 silver screw
securing the
FL inverter board.
2. Carefully lift up the
FL inverter board
and
disconnect the
LCD
/
FL cable
from
CN1
and the
FL
cable
from
CN2
.
3. Remove
four mask seals
to expose four screws
securing the LCD module assembly.
4. Remove
four M2X5 silver screws
securing the
LCD module assembly
.
5. Carefully rotate out the top of the
LCD module
enough to access the display cable
6. Peel off the tape securing the LCD/FL cable and
disconnect the cable.
7. Remove
four
M2x3 silver screws
securing the
right and left LCD brackets.
14.1” DISPLAY MASK REMOVAL
TOSHIBA
Tough Enough for Today’s World.
FIELD REPLACEABLE UNIT DOCUMENTATION
6100 Series
Satellite Pro
TM
Latch
Mask seals
Display
mask
LCD
LCD/
FL harness
FL inverter board
M2x5
silver
screws
M2x3
silver
screws
M2x3
silver
screws
M2x5
silver
screws
FL cable
M2x4 silver screw
LCD module assy
