45
Getting Started
Adding memory (optional)
Installing a memory module
Memory modules can be installed in the memory module slots on
the underside of the computer. You will need a small Phillips
screwdriver for this procedure.
If the computer has been running recently, the memory module(s)
may be hot. The surrounding area may also be hot. Allow the
module(s) to cool to room temperature before replacing it. Avoid
touching the cover, the module(s), and the surrounding area before
they have cooled. Failure to follow these directions could result in
minor bodily injury.
To avoid damaging the computer’s screws, use a small Phillips
screwdriver that is in good condition.
Installing a memory module with the computer’s power on may
damage the computer, the module, or both.
The computer has two memory slots—Slot A and Slot B. You can
install one or two memory modules.
Before you install or remove a memory module, turn off the
computer. If you install or remove a memory module while the
computer is in Sleep or Hibernation mode, data will be lost.
For this model, Slot A is the bottom slot. Slot B is the top slot. If only
one memory module is to be installed, it must be installed in Slot A.
If the computer is on, begin at step
; otherwise, skip to step
1
From the Start or Desktop screen, move your pointer to the
upper-right corner of the screen or swipe in from the right
edge.
2
When the Windows
®
charms appear, click or touch the
Settings
(
) charm.
NOTE
