40
Function setup
Multi brand remote control
The remote control can be compatible with various brands of TV by
setting their control codes. The TOSHIBA code has initially been set
to control TOSHIBA TVs.
Setting TV control codes
Press TV to set the remote control operating
your TV.
1
2
Important
Some TV’s may not respond to all the operations left, or
may not be operated at all with this remote control. In
this case, operate your TV with its own remote control.
Notes:
• For some brands, several control codes (brand codes) are al-
located. Try each of them until the buttons work on your TV.
• If you replace the remote control’s batteries, set the brand code
again.
Table of TV brand codes
Brand No.
TV Brand
Brand No.
TV Brand
Brand No.
TV Brand
01
TOSHIBA
07
PANASONIC
13
SHARP (old)
02
RCA / GE
08
SHARP (New)
14
ZENITH
03
SONY
09
SANYO (FISHER)
15
PANASONIC
04
MITSUBISHI
10
MAGNAVOX
16
PIONEER
05
JVC
11
GOLDSTAR
06
HITACHI
12
SAMSUNG
0–9
PROGRAM
POWER
INPUT SELECT
100
DISPLAY
ENTER
CH+/–, VOL+/–
While holding down PROGRAM enter the two
digits of your TV's brand code (listed below)
using number buttons (0–9), then elease
PROGRAM.
Point the remote control at your TV and use each
button listed berow to make sure that your TV is
operated correctly.
POWER
To turn the TV on or off.
CH +/–
To select TV channels in the upper
or lower direction.
VOL +/–
To adjust the sound level.
INPUT SELECT
To select an external source such
as a VCR.
Number buttons
To select TV channels. When select-
ing channels 1 to 9, first enter 0 and
then desired number.
100
To substitute for 100 channel key.
DISPLAY
To turn on or off TV’s screen dis-
play.
ENTER
To use for the TV’s ENTER key.
(0–9)
2C01501A P38-41
12/16/03, 19:59
40
