13
Introduction
Operation
• Aim the remote control at the remote sensor and press control buttons to
operate.
• Operate the remote control within 30
°
angle on either side of the remote
sensor, up to a distance of approx. 7 meters.
Replace the compartment
cover.
Install two “AAA” batteries
(supplied), paying attention to the
polarity diagram in the battery
compartment.
Open the battery compart-
ment cover in the direction of
the arrow.
Approx. 7 meters
Caution:
Never throw batteries into a fire.
Notes:
• Be sure to use AAA size batteries.
• Dispose of batteries in a designated disposal area.
• Batteries should always be disposed of with the environment in mind. Always dispose of batteries in accordance with
applicable laws and regulations.
• If the remote control does not operate correctly, or if the operating range becomes reduced, replace batteries with
new ones.
• When necessary to replace batteries in the remote control, always replace both batteries with new ones. Never mix
battery types or use new and used batteries in combination.
• Always remove batteries from remote control if they are dead or if the remote control is not to be used for an
extended period of time. This will prevent battery acid from leaking into the battery compartment.
• Press
POWER
to turn the DVD/VCR on or off.
• Select your desired operating mode (DVD or VCR) using
VCR DVD
.
(DVD or VCR indicator on the front panel will show you which mode is selected.)
• Press
CH +
or
CH
– to move through the channels one channel at a time.
• The
/
/
/
are also used to navigate on-screen menu system.
• You can directly access specific channels using
Direct channel selection buttons (0–9)
.
• Each press of
VCR DVD
on the remote control, switches the screen between the VCR screen (VCR mode) and the
DVD screen (DVD mode).
1
2
3
Remote control basics
Inserting batteries
2I30201B-En_p02-13
1/13/06, 2:47 PM
13
Downloaded from
www.Manualslib.com
manuals search engine
Downloaded From Disc-Player.com Toshiba Manuals
