![background image](http://html.mh-extra.com/html/toshiba/strata-airlink-dk40i/strata-airlink-dk40i_installation-and-maintenance-manual_425284145.webp)
DK424 Configuration
Worksheet 4 – Option Configuration Guide
Strata DK I&M 6/00
4-31
DK424 Configur
at
ion
Worksheet 4 – Option Configuration Guide
Option
Number
Required
Comments
RRCS PCB
RRCS-4
RRCS-8
RRCS-12
An RRCS (-4, -8 or 12 DTMF receiver circuits) must be installed on the RCTUA,
RCTUB, RCTUBA/BB, RCTUC/D, or RCTUE/F if the customer has: DTMF DID,
Tie, ANI, DNIS, DISA lines (remote change of call forward destination), DNIS
External Call Routing, using DTMF standard telephones, or voice mail-type
devices with DTMF interfaces
...or if the customer has built-in AA connected to RDSU, RSTU, RSTU2, PSTU, or
PESU standard telephone ports.
Both the RCTUC/D and RCTUE/F can support one RRCS on each PCB, 2
RRCSs total (maximum 24 DTMF receivers). For normal traffic, an RRCS-4 is
sufficient. However, for extremely high traffic, use an RRCS-8, -12, or multiple
RRCSs for large systems.
RKYS1, 2, or 3
If built-in AA ACD, or ACD/MIS is required, one RKYS option key is required see
PIOU/RSIU
Subassembly
PCBs
One IMDU PCB may be installed on the PIOU or PIOUS PCB to provide built-in
remote maintenance modem capability for the Strata DK system.
IMDU PCB
RMDS PCB
One RMDS PCB may be installed on the RSIU PCB to provide built-in remote
maintenance modem for the Strata DK424 system.
RSIS
Up to three RSIS PCBs may be installed on the RSIU PCB to provide one or more
of the following RS-232 interface ports: MIS for ACD, SMDR, SMDI, and/or Local
Maintenance (TTY) Port for DKi Admin/Backup PC.
HESC-65A
One HESC-65A modular connecting cable is required to connect the HESB to the
HHEU in each digital telephone and 6500-series electronic telephone requiring
the Loud Ringing Bell option.
HESB Amplifier/
Speaker
One HESB is required for each digital and electronic telephone providing the Loud
Ringing Bell option.
One HESB is optional to provide single-zone external page connected to either a
PIOU, PIOUS, or PEPU (customer-supplied amplifiers/speakers may be used in
place of the HESB).
One HESB is optional to provide a talkback amplifier/page speaker connected to a
PIOU, PIOUS, or PEPU (a customer-supplied talkback amplifier/page speaker
may be used in place of HESB).
PPTC/PPTC9
Adapter (Modular
to RS-232)
PPTC
(25-pin)
PPTC-9
(9-pin)
PPTC adapter is used to connect an external modem DB25 female connector to a
PIOU/ PIOUS/RSIU/RSIS modular jack. If a PPTC is used, a null modem adapter
is also required.
PPTC9 adapter is used to connect a personal computer DB9 male COM port
connector to a PIOU/PIOUS/RSIU/RSIS modular jack. These adaptors are
required for: SMIS for ACD, SMDI, SMDR, and system maintenance PC or
terminal interface.
Summary of Contents for Strata AirLink DK40i
