Installation
Installation
LVMU Installation Guide 03/06
5
Step 2: Program the Strata CIX
Important!
When installing the LVMU, the Strata CIX system software must be
version
4.20MP026 or higher
. Refer to
for software
and license requirements.
To the Strata CIX processor, the LVMU functions as an analogue card.
The LVMU uses information passed along the backplane of the CIX for it's integration so there are
no special program settings required for the LVMU. In addition no additional equipment is required
(i.e. the BSIS).
Important!
Should the Strata CIX need to be reset to initialize any Strata CIX programming
assignments, it is important that you make all such assignments before installing the
LVMU.
If more detailed information is required around the CIX programming please refer to the Strata CIX
Programming manual.
1.
Log into the Strata CIX via eManager
2.
Configure the nominated CIX slot that the LVMU will be installed into is set as a LVMU.
3.
Assign the LVMU ports in CIX Program 200.
Ensure that the LVMU ports are configured as follows:
-
The station type is enabled for SLT working (FB 02)
-
The circuit type is set to Voice Mail (FB 03).
-
The display DN (FB 15) is set to that of the number assigned to the Pilot Hunt Group
that the LVMU ports will be assigned to.
4.
Set up the Pilot Hunt Group for the LVMU Voice Mail ports, (CIX Program 209/Group Tab).
Ensure the following:
-
The Pilot Number (FB 02) matches the Number to Display (FB 04)
-
The Number to Display (FB 04) matches that programmed for the LVMU Voice Mail
ports Display DN (Program 200, FB 15)
-
The DHG Auto Camp On (FB 07) is Enabled.
5.
Assign the LVMU Voice Mail Ports to the Pilot Hunt Group, (CIX Program 209/Member Tab).
6.
Using CIX Program 579, System Voice Mail Data, ensure the following is programmed:
-
the Output of Class/ANI and DNIS (FB 04) is Enabled
-
the Pilot DN of the Voice Mail is set as a direct transfer destination by entering the
Pilot Hunt Group Number, assigned in CIX Program 209, as the Transfer Direct to VM
DN (FB 16).
7.
Using CIX Program 580, Voice Mail Port Data, configure each of the LVMU Voice Mail ports.
Ensure that:
-
The Control Method (FB 01) is set to SMDI
-
Send A/D Tone (FB 02) is Enabled
-
End to End Signalling (FB 06) is Enabled
-
VM to VM Call Blocking (FB 05) is set for Blocking
