Strata CTX Programming 6/04
xi
Introduction
This manual provides information required to program the Strata CTX28, CTX100-S, CTX100
and CTX670 business telephone systems using Toshiba’s CTX WinAdmin™ software or Button
Programming.
Important!
Whenever the CTX100 is mentioned in this book, it applies to both the CTX100-S
and CTX100, unless specified otherwise.
This programming manual only applies to CTX WinAdmin version 2.20G. If you
have CTX WinAdmin versions 2.1D or lower, refer to previous versions of this
manual.
Note
The features described in this document assume that the Strata CTX system has the current
software release installed. At the time of printing, Strata CTX R2.2 and CTX WinAdmin
R2.20 are the most current versions.
Organization
Part 1: Getting Started
Chapter 1
-
Programming Guidelines
describes auto-recognition features, order of
programming, and overview of general CTX WinAdmin and Button Programming operation.
Part 2: CTX WinAdmin Programming
Chapter 2 – CTX WinAdmin Overview
provides general information about CTX WinAdmin’s
software capabilities.
Chapter 3 – Installation
discusses system hardware and software requirements for
CTX WinAdmin and includes the installation steps needed to install CTX WinAdmin.
Chapter 4 – System
provides system programming information.
Chapter 5 – Station
discusses station and station feature programming.
Chapter 6 – Trunks
explains trunk programming information including T1, ISDN Basic Rate
Interface (BRI) and Primary Rate Interface (PRI).
Chapter 7 – Attendant
describes Attendant Console support and settings available in
CTX WinAdmin.
Chapter 8 – IP Telephone
describes the programs required to program IP Telephone features.
Summary of Contents for Strata CTX 100-S
