Paper loading
1. Open the top cover
B
.
2. If there is any unused paper or if there is an empty paper roll core in the paper
roll holder inside the printer, remove it before inserting a new paper roll
A
. You
can discard the empty paper core.
3. Drop the roll into the bucket
D
. The leading edge of the paper should come
from the direction of the back of the printer and go across the bottom of the roll
as shown in the diagram. See Figure 6.
Note:
The thermal print head will not print on paper with glue on it. If the new
paper roll was sealed by glue, tear off the 15 to 20 cm (6 to 8 in.) of
paper with glue on it before loading it.
4. Pull the end of the paper up over the paper roll and toward the back of the
printer.
Note:
Refer to the label on the inside of the bottom cover for a diagram of how
to load paper.
5. Close the paper cover.
6. Press the customer receipt feed button to advance the paper and verify that the
paper is feeding correctly. Feed 30 cm (about 1 ft) of paper through to test for
correct alignment.
Attention:
Do not pull the receipt paper out of the printer with the paper access
cover closed. This might cause partial lines of print. Use the customer receipt feed
button to advance the receipt.
A
B
C
D
A
Paper roll
C
Metal spring
B
Top cover
D
Bucket
Figure 6. Paper loading path
8
4610- SJ6 Fiscal Printer User's Guide
Summary of Contents for SureMark 4610-SJ6
