Testing the printer
When you power on the SureMark printer, it runs a power-on self-test (POST). If the
POST finds no errors, the printer is ready for operation. Follow this procedure to
determine if there are errors.
Note:
Never connect or disconnect the printer when power is applied (when the
LED is on).
1. If the printer is turned on, use the power switch to turn
Off
the printer and turn it
On
again.
B
A
C
2. Check the status of the Printer Ready indicator
B
:
Printer Ready indicator On:
The POST completed successfully.
Printer Ready indicator Off or blinking:
The POST failed.
3. If the POST fails or if you suspect problems with your system, see “Problem
determination” on page 14.
4. See “Offline test” and run the offline test. If the offline test fails or you suspect
problems with your system, see “Problem determination” on page 14.
Offline test
An offline printing test is provided as a diagnostic tool to ensure the printer is
operating correctly.
1. Open the top cover
A
.
2. Press and hold the paper feed button
C
for five seconds. The LED indicator will
make one quick flash followed by a pause. The beeper will make a short single
tone periodically.
Note:
The paper feed button is the small button next to the LED.
3. Release the paper feed button.
4. Close the top cover.
12
4610- SJ6 Fiscal Printer User's Guide
|
Summary of Contents for SureMark 4610-SJ6
