T2100 Series
4-7
Installing the Battery Pack
CAUTION:
There is danger of explosion if the battery is incorrectly replaced. Use
only the same or equivalent battery recommended by Toshiba. Return spent batteries
to your dealer for environmentally safe disposal.
To install a battery pack, follow the steps below and refer to Figures 4-3 and 4-2.
1.
Turn the computer’s power off.
2.
Carefully insert the new or recharged battery pack. Set the grooved end against
the battery contacts first, then lay the battery in place. Be sure the end of the
plastic tab lies on top of the battery (Figure 4-3).
CAUTION:
When you close the palm rest, cables to the AccuPoint buttons
are exposed. Be careful not to apply tension to these cables or to pinch them
when you close the palm rest.
3.
Close the palm rest and gently push it into position (Figure 4-2).
4.
Push the latches back into place, pressing gently until you feel them click (Figure
4-2).
Summary of Contents for T2100 Series
