70
PROBLEM SOLVING
En
glis
h
a
Set the Colour to
Auto
and exit.
b
Go to the
PICTURE
menu and adjust the tint.
Q
What is DVB-T?
A
Digital Video Broadcast via an aerial/antenna.
Q
What is DVB-C?
A
Digital Video Broadcast via a cable connection.
Q
How are DTV radio channels selected?
A
Select from All Channel List (
LIST
button).
Q
What can be done if the PIN number has been
forgotten?
A
Use the Master PIN code of 1276, then change to a
number of your choice. Select
Parental PIN Setup
from the
DTV Settings
menu to enter PIN. Ensure
that no-one else can use the Master PIN by removing
the Owner’s Manual.
Q
Why are there vertical stripes on the screen when
in PC mode?
A
The
Sampling Clock
may need adjustment. Select
PC
Settings
from the
Display Settings
menu, highlight
Sampling Clock
and adjust until the lines clear.
Q
Why are there horizontal stripes and/or blurred
images on the screen when in PC mode?
A
The
Clock Phase
may need adjustment. Select
PC
Settings
from the
Display Settings
menu, highlight
Clock Phase
and adjust until the picture clears.
Q
Why when
digital
subtitles have been selected are
they not showing on screen?
A
Subtitles are not currently being transmitted by the
broadcaster.
Q
Why are there problems with analogue text?
A
Good performance of text depends on a good strong
broadcast signal. This normally requires a roof or loft
aerial. If the text is unreadable or garbled, check the
aerial. Go to the
main index
page of the text service
and look for the
User Guide
. This will explain the basic
operation of text in some detail. If further information
is needed on how to use text
see the text section
.
Q
Why is a page number visible at the top of the
screen but no text?
A
Text has been selected but Teletext information is
currently unavailable on the current source.
Q
Why are the colours wrong when an NTSC source
is played?
A
Connect the source via a SCART lead and play.
Select
Colour System
from the
Setup
menu.
Q
Why don’t the devices connected via HDMI
operate properly?
A
Make sure to use cables with the HDMI logo
(see page 10).
Some early HDMI equipment may not work properly
with the latest HDMI TV products, due to new
standard adoption.
Q
Why don’t the REGZA-LINK devices work?
A
When the connected REGZA-LINK device does not
work correctly after you have changed the settings of
the device, turn off your television and unplug the
power cord, and then plug and turn on again. Unplug
the HDMI cable of the REGZA-LINK device and lead
again.
Q
Why is the REGZA-LINK logo still showing when
the equipment has been disconnected?
A
If the REGZA-LINK device is disconnected, the logo
will disappear after approximately one minute.
Q
Why don’t the networked devices work?
A
The LAN cables are not connected properly or at all.
Connect all cables (see page 13).
Make sure your network address is set up correctly
(see page 41).
Q
Why doesn’t the wireless network work?
A
Make sure the TOSHIBA Dual Band WLAN Adaptor is
used (see page 13).
Check that the AP is powered on.
Summary of Contents for TL93 Digital Series
Page 1: ...TL93 Digital Series ...