TMP86PM29BUG
The Functional Differences on Products basis: TMP86C829B/CH29B/CM29B/PM29A/
PM29B/FM29/CM29L.
Note 1: UART and SIO can not use function synchronously because each function pins are shared.
Note 2: An emulation chip (TMP86C929AXB) can’t emulate the Flash memory functions, CPU wait and serial PROM mode.
Therefore, if the software which includes Flash memory function or CPU wait is executed in TMP86C929AXB, the opera-
tion might be different from TMP86FM29/CM29L.
Note 3: The operating temperature (Topr) of AD characteristics of all products (TMP86C829B/CH29B/CM29B/PM29A/PM29B/
FM29/CM29L) is -10
℃
to 85
℃
when the supply voltage VDD is less than 2.0V. For details, please refer to "AD Conversion
Characteristics" in data sheet of each product.
Note 4: The typical value of high and low frequency feedback resistor in TMP86FM29/CM29L are different from that of the other
products. For details, please refer to "Input/Output Circuitry" in data sheet of each product.
Note 5: The characteristic of power supply current differs in each product. For details, please refer to "Electirical Characteristics"
in data sheet of each product.
Note 6: The recommended operating condition of serial PROM mode in TMP86FM29 is different from MCU mode. Fore details,
please refer to "Electirical Characteristics" in data sheet of each product.
Products name
TMP86C829B
TMP86CH29B
TMP86CM29B
TMP86PM29A
TMP86PM29B
TMP86FM29
TMP86CM29L
ROM
8K bytes
(MASK)
16K bytes
(MASK)
32K bytes
(MASK)
32K bytes
(OTP)
32K bytes
(FLASH)
32K bytes
(MASK)
RAM
512 bytes
1.5K bytes
DBR
128 bytes
(Flash memory control/status registers <EEPCR, EEPSR> are non-available.)
128 bytes
(Flash memory control/status registers
<EEPCR, EEPSR> are available.)
I/O port
39 pins
Large current output
(Nch) port
4 pins (Sink-open-drain output)
20 mA (Typ)
4 pins (Sink-open-drain output)
6 mA (Typ)
Interrupt sources
External: 5 Internal: 14
Timer/Counter
18bit Timer/Counter: 1ch
8bit Timer/Counter: 4ch
UART/SIO
1ch (Note1)
Key-on wakeup
4ch
AD converter
10bit x 8ch (Note3)
LCD driver
32SEG x 4COM
Circuitry of TEST pin
Feedback resistor in
High- frequency circuit
(Note4)
R
f
= 1.2 M
Ω
(Typ)
R
f
= 3 M
Ω
(Typ)
Feedback resistor in
Low- frequency circuit
(Note4)
R
f
= 6 M
Ω
(Typ)
R
f
= 20 M
Ω
(Typ)
Emulation Chip
(Note2)
TMP86C929AXB
Package
P-QFP64-1414-0.80C
P-LQFP64-1010-0.50E
P-LQFP64-1010-
0.50D
Operating voltage
(Note 5)
1.8V to 5.5V at 4.2MHz/32.768kHz
2.7V to 5.5V at 8.0MHz/32.768kHz
4.5V to 5.5V at 16MHz/32.768kHz
1.8V to 3.6V at 8.0MHz/32.768kHz
2.7V to 3.6V at 16MHz/32.768kHz
(Note 6)
VDD
R
IN
R
R
No Pull down
Resistor
No Protection
Diode (VDD side)
VDD
R
IN
R
Summary of Contents for TLCS-870/C Series
